ALTRONIX AL1024ULXPD4CB Power Supply / Charger- 24VDC 10 Amp. With four (4) PTC outputs. AC fail low battery.
[AL1024ULXPD4CB] |
Call for price |
|
 |
Features
- 24VDC @ 10 amp supply current.
- Power supply input options:
- One (1) common power input for ACM8/
ACM8CB and lock power (factory installed).
- Two (2) isolated power inputs - One (1) to power
the ACM8/ACM8CB and one (1) for lock
accessory power, (external power supply
is required). (Current is determined by the
power supply connected, not to exceed a
maximum of 10 amp total).
- Eight (8) Access Control System trigger inputs.
Input options:
- Eight (8) normally open (NO) inputs.
- Eight (8) open collector inputs.
- Any combination of the above.
- Eight (8) independently controlled outputs.
Output options:
- Eight (8) Fail-Safe and/or Fail-Secure
power outputs.
- Eight (8) form “C” 5 amp rated relay outputs
(AL1024ULACM only).
- Any combination of the above.
- Eight (8) auxiliary power outputs (unswitched)
- Output ratings:
- Fuses are rated @ 3.5 amp (AL1024ULACM).
- PTCs are rated @ 2.5 amp
(AL1024ULACMCB).
- Input 115VAC 60Hz rated @ 4.4 amp.
- ACM8 board main fuse is rated at 10 amp.
- Filtered and electronically regulated outputs
(built-in power supply).
- Short circuit and thermal overload protection.
- Red LEDs indicate outputs are triggered
(relays energized).
- Fire Alarm disconnect (latching or non-latching) is
individually selectable for any or all of the
eight (8) outputs.
- Fire Alarm disconnect input options:
- Normally open (NO) or normally closed (NC)
dry contact input.
- Polarity reversal input from FACP
signaling circuit.
- Alarm output relay indicates that FACP input
is triggered (form “C” contact rated @ 1 amp 28VDC
not evaluated by UL).
- Green LED indicates when FACP disconnect
is triggered.
- Built-in charger for sealed lead acid or
gel type batteries.
- AL1024ULXB (Power Supply Board)
maximum charge current 3.6 amp.
- Automatic switch over to stand-by battery
when AC fails.
- Zero voltage drop when unit switches over to battery
backup (AC failure condition).
- AC fail supervision (form "C" contact).
- Battery fail and battery presence supervision
(form "C" contact).
- AC input and DC output LED indicators.
- Enclosure accommodates up to two (2)
12AH batteries.
|
